# daemon started from an initscript.
listen=YES
# Allow anonymous FTP? (Beware - allowed by default if you comment this out).
anonymous_enable=NO
# Schalter, um Account aus einer Liste zugriff zu verbieten
userlist_enable=YES
# Liste mit zugriffsberechtigen usern
userlist_file=/etc/vsftpd.user_deny
# Uncomment this to allow local users to log in.
local_enable=YES
# Uncomment this to enable any form of FTP write command.
write_enable=YES
# Default umask for local users is 077. You may wish to change this to 022,
# if your users expect that (022 is used by most other ftpd's)
local_umask=022
# Uncomment this to allow the anonymous FTP user to upload files. This only
# has an effect if the above global write enable is activated. Also, you will
# obviously need to create a directory writable by the FTP user.
anon_upload_enable=NO
# Uncomment this if you want the anonymous FTP user to be able to create
# new directories.
anon_mkdir_write_enable=NO
# Activate directory messages - messages given to remote users when they
# go into a certain directory.
dirmessage_enable=YES
# Activate logging of uploads/downloads.
xferlog_enable=YES
# Make sure PORT transfer connections originate from port 20 (ftp-data).
connect_from_port_20=YES
# You may override where the log file goes if you like. The default is shown
# below.
xferlog_file=/var/log/vsftpd.log
# If you want, you can have your log file in standard ftpd xferlog format
xferlog_std_format=YES
# You may change the default value for timing out an idle session.
idle_session_timeout=600
# You may change the default value for timing out a data connection.
data_connection_timeout=120
# You may fully customise the login banner string:
ftpd_banner="Welcome to da-checka's FTP." 
chroot_local_user=YES
# This option should be the name of a directory which is empty.  Also, the
# directory should not be writable by the ftp user. This directory is used
# as a secure chroot() jail at times vsftpd does not require filesystem
# access.
secure_chroot_dir=/var/run/vsftpd
# This string is the name of the PAM service vsftpd will use.
pam_service_name=vsftpd
# Einstellungen fuer ssl-verschluesselung
ssl_enable=YES
allow_anon_ssl=NO
force_local_data_ssl=NO
force_local_logins_ssl=NO 

ssl_tlsv1=YES
ssl_sslv2=NO
ssl_sslv3=NO

# This option specifies the location of the RSA certificate to use for SSL
# encrypted connections.
rsa_cert_file=/etc/vsftpd.pem

# Diese Option gibt an, dass die Lokale Systemzeit und nicht GMT genutzt wird
use_localtime=YES

# Einstellungen fuer den SSL-verschluesselten Datenverkehr von aussen
# Die angegebenen Ports muessen in der FritzBox weitergeleitet werden
#pasv_addr_resolve=yes
#pasv_address=da-checka.ath.cx
pasv_min_port=22000
pasv_max_port=22015
pasv_promiscuous=YES
setproctitle_enable=YES
session_support=YES